6
English
Instructions for use
Note
• Bear in mind that factors such as the size of the room, the outside temperature
and how well the building is insulated, all affect the ability of the heater to warm
the room up. If the room is too large the ability of the heater to warm it up to
the desired temperature may be insufficient.
• The fan heater must be standing upright on a level surface to ensure that the tip-
over switch doesn’t trip.
1. Place the fan heater on a flat and stable surface.
2. Plug the fan heater into a wall socket.
Fan only mode
1. Turn the thermostat knob (1) to the maximum setting.
2. Turn the mode selector (3) to to switch the fan on, the indicator light (2) will come on.
3. Turn the mode selector to
0
to switch the fan off, the indicator light will go out.
Fan with heating
1. Turn the thermostat knob clockwise to the maximum setting.
2. Turn the mode selector to
I
(750 W) or
II
(1500 W) to switch the fan heater on,
the indicator light will come on.
3. When the desired ambient temperature has been reached, slowly turn
the thermostat knob back until it clicks and the fan heater switches off.
Leave the thermostat knob in that position.
4. The fan heater will maintain the set temperature by automatically switching on and off.
5. The temperature can be adjusted by turning the thermostat knob:
-
clockwise to raise the temperature
-
anticlockwise to lower the temperature.
6. Turn the mode selector to
0
to switch the fan heater off, the indicator light will go out.
Oscillation function
1. Set the switch [ 1/0 ] (5) on the rear of the fan heater to
I
to switch the oscillation
function on.
2. Set the [ 1/0 ] switch to
0
to disengage the oscillation function.
Overheating protection
The fan heater is fitted with an overheating safety cut-off protection device which
switches the fan heater off if it overheats.
To reset the overheating protection device:
1. Turn the mode selector to
0
.
2. Unplug the fan heater from the wall socket and let it cool for 5–10 minutes.
3. Then plug the heater back into a wall socket. The heater should now work normally.
