8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
INSERTING/REMOVING THE DRILL BIT
1. Open the chuck jaws by gripping
the chuck key in one of the holes
in the chuck and turning it as
shown.
2. Make sure that the head of the
chuck key is located on the barrel
of the chuck.
3. Turn the chuck key until the chuck
jaws are open sufficiently to
accept the drill bit.
4. Insert the drill bit in the jaws of the
chuck as far as it will go without
gripping the cutting part of the bit.
5. Close the chuck jaws and tighten
to grip the drill bit by turning the
chuck key as shown.
6. Make sure that the chuck jaws are
fully closed and that the drill bit is
held firmly.
Your drill is now ready for use.
OPERATION
SETTING THE SPEED
1. Set the tool speed by rotating the
control to one of the four settings.
• The numbers on the speed
control knob indicate the
speed setting when aligned
with the reference mark on the
air inlet. Speeds available are
(+/-10%):
1
11,000 rpm
2
15,000 rpm
3
18,000 rpm
4
20,000 rpm
Drill bit
Chuck jaws
Close
Open
Chuck
key
jaws
jaws
Barrel
Содержание X-Pro CAT207
Страница 16: ......
