Clarke X-Pro CAT207, Инструкция по эксплуатации и обслуживанию

Страница: 9 / 16

9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
OPERATING THE DRILL
1. Slide the throttle locking lever
forward while squeezing the
trigger against the body of the
tool.
2. Do not use excess pressure on the
drill bit as this will shorten its life.
3. Release the trigger to stop the
drill.
• The drill will continue to rotate
briefly after the trigger has
been released.
4. Always ensure the drill has stopped before putting it down.
SETTING THE EXHAUST DEFLECTOR
The direction of the exhaust air
leaving the tool can be adjusted by
rotating the exhaust deflector.
Twist the exhaust deflector sleeve to
direct the air as required to deflect air
away from the workpiece or operator.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session.
STORAGE
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
CLARKE air line oil into the air inlet, and run the tool for 5 seconds in order to
lubricate the internal parts.
When not in use, disconnect from air supply, clean tool and store in a safe, dry
place. When storing, replace the blanking plug to the air inlet once the airline
is disconnected.