Clarke WOODWORKER CWL325V, Инструкция по эксплуатации и техническому обслуживанию

Страница: 9 / 16

9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ASSEMBLY
1. Screw the tailstock spindle into the
tailstock as shown in Fig 1.
• Note: A left-hand thread is used
for this.
2. Attach the tailstock spindle
locking lever and the tailstock
locking lever in their positions
using the coil spring and machine
screw provided.
3. Attach the tool rest locking lever
and the support locking lever in
their positions using the coil spring
and machine screw provided for
each as shown in Fig 2.
4. Install the tool rest of your choice
into the hole in the tool rest
support. Position the working
edge of the rest parallel with the
centre axis of the lathe and
secure with the tool rest locking
lever. The position of the support
will be adjusted to suit the workpiece.
5. Screw the faceplate onto the headstock
spindle while inserting the drift rod into
the hole in the spindle to prevent it from
turning. Tighten the faceplate using the
open spanner provided as in Fig 3.
6. If the work is to be held in position
between the headstock and tailstock,
insert the headstock spur into the
tapered hole in the headstock spindle.
• If the faceplate is fitted, the spur can be
removed from the headstock by
unscrewing the faceplate with the
spanner in the usual way. With no
faceplate, the spur can simply be
tapped out by inserting the drift rod
through the spindle.