10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
1. Press the green push-button to start the lathe and adjust the speed using
the speed control knob.
2. Always use the lowest speed when starting a new workpiece.
3. Always rotate the workpiece by hand before turning on the motor and
check it does not strike the tool/tool rest.
4. Ensure tool rest and tailstock are securely locked in position before starting
work.
5. Always position the tool-rest just above the centre-line of the lathe.
6. Avoid turning timber which has splits or substantial knots or voids and take
special care if these are discovered.
7. When turning, always roughly turn the work to a round form at slow speed.
8. Take care that the turning tools do not bite suddenly into the workpiece.
MAINTENANCE
For maximum performance, it is essential that the machine is properly
maintained. Always inspect before use. Any damage should be repaired and
faults rectified. The machine requires very little maintenance other than the
following guidelines.
IMPORTANT: Disconnect from mains power before cleaning.
1. Vacuum clean any dust or shavings that accumulate in or on the motor.
2. Check all cables periodically and ensure that they are in good condition
and not cracked.
3. Check the tightness of the mounting bolts.
4. Check the drive belt for wear and replace if it is frayed or otherwise
damaged.
5. Periodically lubricate the tail-stock, screw threads with engine oil such as
SAE20 or SAE30 grade if they become stiff to use.
6. Lightly lubricate the tail-stock and tool-post locking handles with oil if they
become difficult to use.
•
The ball bearings in the headstock and tail-stock spindles are greased and
permanently sealed at the factory and require no further lubrication.
Содержание WOODWORKER CWL325V
Страница 16: ......
