Clarke Woodworker CMS254, Инструкция по эксплуатации и обслуживанию

Страница: 17 / 21

b. Squareness of Backfence
Place a square flat on the table with its base resting on the Backfence.
If it is not square with the edge of the slot in the table, slacken off the two
backfence securing screws D, sufficient to be able to move the fence
until it is square.
When satisfied, tighten the securing screws.
c. 45° Bevel Stop
Slacken off the Bevel lock (C), and tilt the Head to its maximum.
Lower the Blade and with a small 45° gauge between the bed and blade,
check for trueness of angle.
If an adjustment is required, slacken the adjuster locknut shown at B. and
screw the adjuster in or out as the case may be to acquire the correct
angle, and when satisfied, lock the adjuster with the locknut.
d. Cutting Head Spring Tension
To increase or decrease Cutting Head spring tension, slacken off the locking
screw at adjuster (E) and screw the adjuster in to increase or out to
decrease tension, and tighten the locknut when completed.
17
For Spare Parts and Service, please contact your nearest dealer,
or CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: Parts@clarkeinternational.com
SERVICE: Service@clarkeinternational.com
PARTS AND SERVICE CONTACTS