Clarke Woodworker CMS254, Инструкция по эксплуатации и обслуживанию

Страница: 10 / 21

On receipt inspect the machine to ensure that all parts are accounted for
and that no damage was incurred during transit. Any deficiency or
damage should be reported to your CLARKE dealer immediately.
The main body of the saw is fully assembled and adjusted at the factory.
It is necessary only to fit the accessories supplied, shown below.
ASSEMBLY and INSTALLATION
Mount the machine on a firm solid base that will not move under load.
Ensure there is an appropriate electrical supply, and adequate lighting,
so that you will not be working in your own shadow.
Four holes are provided in the base, shown at A fig. 3, so that the machine
may be bolted permanently to a workbench for added stability.
Alternatively it may be bolted to a piece of plywood with a thickness of 5/
8” minimum. If this method is preferred, the plywood support should be
clamped to a solid base or workbench whenever the saw is being used.
Accessories provided with the machine
The Work Stop may be slipped
on to one arm of the right hand
work support before as shown in
fig. 5. The wing nut secures the
stop at any desired position, or
the stop may be swiveled out of
the way when not required.
Attach the Work Supports, one
to each side of the bed using the
Work Support Clamps.
Fig.4
Fig.5
10