Clarke WCP150, Руководство по эксплуатации и техническому обслуживанию

Страница: 3 / 16

3
SET UP
NOTE: Use good quality alkaline batteries.
1. Have the indoor weather station and remote temperature sensor close
together during setup.
2. Install the batteries into the remote sensor first, then into the weather
station. See below.
INSTALLING THE BATTERIES
REMOTE SENSOR (FIG 1)
1.
Fig 1
Remove the battery
compartment cover.
2. Insert two alkaline AA batteries
into the remote sensor.
NOTE: Make sure that you follow
the polarity diagram inside
the battery compartment.
3. Replace the battery
compartment cover.
INDOOR BASE STATION (FIG 2)
1.
Fig 2
Remove the battery cover.
2. Observing the correct polarity,
install three alkaline AA batteries.
3. Replace the battery cover.
4. Do not press any buttons for at
least ten minutes. This will allow
time for the weather station to start
receiving information from the
sensor,
• If successful the indoor weather station will show the sensor temperature
and humidity.
• If the indoor weather station does not display these values after 1
minute, the signal search will try again every two hours until a signal is
found.
• Once the remote sensor temperature and humidity values are displayed
for 10 minutes you can place the sensor outdoors.