Clarke WCP150, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 16

10
8. Press the MIN/MAX button or + button to select the period you want to
measure rainfall over.
NOTE: When total is selected, pressing SET for 2 seconds will reset the
total to zero.
9. Press the SET button again to make the selection and return to normal
mode.
GENERAL SETTINGS
1. Press and hold the SET button for 3 seconds or until the base station beeps
to enter the “general settings” mode.
2. Press the SET key again to cycle through the following settings.
• Time Zone Setting: the default time zone setting value is -1 based on
Germany DCF time (GMT +1)
• 12/24 hour format
• Manual time setting (hours/minutes)
• Calendar setting (year /month /date)
• Temperature display unit (degrees Celsius or Fahrenheit)
• Air pressure display units in hPa (hectopascals) or inHg (inches of
mercury)
• Relative Pressure setting from 919.0 hPa - 1080.0 hPa (default 1013.2
hPa)
• Pressure Threshold setting (default 2 hPa) - The lower level pressure
threshold setting, the higher sensitivity for weather forecasting
• Storm threshold setting (default 4 hPa)
• Wind speed and gust display units (km/h, mph, m/s, knots, bft)
• Rainfall display units (mm or inches)
3. Press the + button to increase or MIN/MAX button to decrease the value of
the setting.
NOTE: Pressing and holding the + button or MIN/MAX button will adjust
the values in greater steps.
4. Press the HISTORY button to return to Normal mode.