Clarke Strong-Arm CPL30T, Инструкция по эксплуатации и обслуживанию

Страница: 13 / 40

International
13
Maintenance
Required maintenance/inspection periods
The maintenance/inspection periods are stipulated as follows:
• The operator (owner) is obliged to maintain a maintenance/inspection log.
• The time between technical inspections of the lift by authorised personnel of
the manufacturer is maximum 12 months.
• The interval for the maintenance works to be carried out by the operator is
maximum 1 month.
• The completion of all inspections, repair works, the replacement of spare
parts or unusual operating conditions must be recorded in the maintenance/
inspection log.
Points and components requiring regular maintenance/inspection
• The lubrication of the spindle is done over oil-soaked felt pads.
• The oil level must be checked regularly; if the level should range under 50
mm the tank must be filled to its upper brim.
• For the lubrication of the chain, grease type LZS-3 or a gear lubricant oil with
high viscosity is used.
• The thrust bearings located on the top of the posts must be lubricated using
grease type LZS-3.
• The lower and upper bearings must be lubricated with grease type LZS-3 once
a year.
• The swivel arm locks are to be lubricated every six months using gear lubricant
oil with a high viscosity.
• All other sliding surfaces are to be lubricated with a gear lubricant oil or grease
type LZS-3 once a year.
• The wear indicator of the nut system must be checked monthly (see Fig. 9).
MAINTENANCE