Clarke Power Wash EHD130, Инструкция по эксплуатации и обслуживанию

Страница: 5 / 14

high pressure
hose
pressure
regulator
5
ASSEMBLY AND PREPARATION FOR USE
The machine is fully assembled except for the lance and hose
connections
The high pressure hose is attached to the
lance just forward of the trigger assembly, the
other end to the high pressure outlet at the
front of the machine. Take care not to cross
thread the BSP threads.
The low pressure water inlet is located
adjacent to the high pressure outlet, that is,
to the left front of the machine, looking from
the front. (see Fig.2)
The lance is in two sections, assemble
by screwing the two halves together.
A 3/4” BSP adapter with a 1/2” hose
connector is provided, so that a suitable
hose (not supplied), may be attached,
with a worm drive clip (not supplied), or a
quick fit coupling (available from most
hardware or DIY stores), and connected
to your water supply.
We recommend that you connect a filter
(arrowed In Fig.4) to the inlet hose, to
prevent the possibility of foreign bodies
entering and damaging the pump.
Only use a CLEAN water supply.
High Pressure Outlet
Fig.1
Fig.2
Fig.3