Clarke Power Wash EHD130, Инструкция по эксплуатации и обслуживанию

Страница: 7 / 14

7
In doing so the pump will stop and start again when the trigger is pulled once
again.
For the reasons given above, it is recommended that you ALWAYS set the lance to
its LOW PRESSURE setting before switching ON.
WARNING
Ensure the operator is aware that when the trigger is pulled, water at
high pressure can cause the lance to kick - it should therefore be held firmly. In
addition, care must be taken to ensure that the nozzle is NOT aimed at an area
where the water jet will cause damage. i.e. away from people, animals, windows
- greenhouses etc., and be aware that splash back could also cause damage if
the jet is trained on a nearby wall etc.
If you wish to use the chemical injection facility, note that it will ONLY operate at
LOW pressure.
Turn the pressure control handle to its’ LOW pressure setting. When you pull the
trigger, detergent will be drawn up into the water flow.
NOTE : Water pressure is regulated by
turning the adjuster handle located in the
middle of the lance and which doubles
as a hand grip, ANTICLOCKWISE to
INCREASE pressure and CLOCKWISE to
DECREASE, (looking from the handle end).
Forwards (anticlockwise)
to INCREASE pressure
In the event that you switch the machine OFF, but
intend to continue with its use after a few minutes
or so, DO NOT depress the trigger, but set the safety
latch (arrowed in fig.7) to prevent it from being
accidentally pulled. This will ease and assist the
subsequent restarting of the motor as pressures will
remain equalised on either side of the pump,
thereby reducing the load on the motor when
restarting.
NEVER attempt to run the machine with water supply disconnected or turned off.
It is recommended that whenever possible, a screen or partition be erected
between the washer and the wash area, to prevent accidental spraying of the
machine. Any moisture entering the machine could cause serious damage.
Fig.6
Fig.7