Clarke Power Wash EHD130, Инструкция по эксплуатации и обслуживанию

Страница: 6 / 14

6
If you intend to use the chemical injection facility,
fill the detergent tank with the requisite detergent.
The filler cap is located directly beneath the
handle (fig.4)
IMPORTANT:
Use ONLY those detergents specifically designed
for use with Power Washers. We recommend the
use of CLARKE Traffic Film Remover, which is a
powerful low foaming agent for car cleaning,
patio cleaning etc., or CLARKE Wash & Wax, both
available from your CLARKE dealer.
N
OTE : The chemical injection facility will ONLY
operate at the LOW pressure setting. (See
‘Operation’)
Fig.4
OPERATION
• Make certain the PUMP ON/OFF switch is set in the OFF position.
The ON/OFF switch is mounted on the top panel.
• Turn the water tap fully on.
• Start according to the following procedure:
a. In order to ease the starting process, and to prevent the possibility of
blown fuses, pull the trigger on the lance - it may be necessary to release
the safety latch in order to do so.
b. Hold the trigger in that position whilst switching the pump ON, and allow
the pump to run for a few moments to develop full pressure.
c. You may release the trigger once full pressure is developed.
The amount of detergent that enters the system
may be regulated by turning the knurled ring,
arrowed in fig.5.
Turning the ring clockwise - decreases, and
turning anticlockwise - increases the amount of
detergent injected.
Maximum, provides a mixture strength of approx.
15:1 - approx. 1000:1
Fig.5