Clarke Metalworker CL251MH, Инструкция по эксплуатации и обслуживанию

Страница: 13 / 16

4. Mill Chuck Set
A set of 6 collets with chuck with sizes:
• 3mm
• 4mm
• 5mm
• 6mm
• 8mm
• 10mm
Part Number: 7601853
1. Insert the shank of the chuck into the Mill Head Spindle and screw on to the end of the draw bolt,
shown a ‘A’ Fig 7 on page 12. Tighten the draw bolt, holding the spindle steady by hand or by
using a tommy bar (not provided) in the hole provided in the spindle.
2. Unscrew and remove the end collar ‘A’, insert the appropriate collet and reattach the end collar.
3. Insert the respective end mill into the collet and tighten using the ‘C’ spanner.
To remove the chuck, undo the draw bolt a turn or two, then tap its’ head using a mallet to break the seal.
A
13
5. Drill Chuck with Key
Insert the shank of the chuck into the spindle and
screw on to the end of the draw bolt, shown at ‘A’
Fig 7 on page 12.
Tighten the draw bolt, holding the spindle steady
by hand or by using a tommy bar (not provided),
in the hole provided in the spindle.
To remove the chuck, undo the draw bolt a turn or
two, then tap its’ head using a mallet to break the
seal.
Part Number: CL251MH910
NOTE: This tool is supplied with the machine.
For Spare Parts or Servicing, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS - 020 8558 6696 : SERVICE - 020 8556 4443
PARTS & SERVICE FAX - 020 8 558 3622
PARTS E-MAIL - Parts@clarkeinternational.com
SERVICE E-MAIL - Service@clarkeinternational.com
SPARE PARTS & SERVICING