Clarke ELS140, Инструкция по эксплуатации и обслуживанию

Страница: 9 / 14

IMPORTANT: The chemical injection
facility will ONLY operate at LOW
pressure.
If you intend to use the chemical
injection facility, fill the detergent tank
with the requisite detergent. The filler
cap is located directly beneath the
handle
Alternatively, provision is made so that
an external source of detergent may
be used. To do this, first disconnect the
hose from the reservoir to the pump,
at the pump connection shown at A.
fig. 4 and also at A in fig..6, and in its
place, connect the length of hose
CHEMICAL INJECTION FACILITY
supplied and lower it into a drum of detergent.
The amount of detergent that enters the system may be regulated by turning the
knob shown at B, fig. 6. The total movement of the knob is approx. 1/8 of a turn
from Max. to Min.
Max. provides a mixture strength of approx. 15:1...Min-approx. 1000:1.
Use ONLY those detergents specifically designed for use with Power Washers. We
recommend the use of CLARKE Traffic Film Remover, which is a powerful low
foaming agent for car cleaning, patio cleaning etc., or CLARKE Wash & Wax,
both available from your CLARKE dealer.
IMPORTANT: Ensure you read and comply with the manufacturers instructions
regarding the use of chemical detergents.
SHUTTING DOWN THE MACHINE
If the chemical injection facility has been used, turn the pressure adjuster on the
end of the lance to HIGH pressure, and allow the pump to run for a minute or so
until the water being ejected is foam free, then switch OFF the pump.
Disconnect from the mains electrical supply, and turn OFF the water supply -
disconnect where appropriate.
IMPORTANT:
ALWAYS operate the lance trigger once more to ensure there is no pressure in the
high pressure hose. NEVER disconnect the high pressure hose without first pulling
the trigger.
Fig.6
9