Clarke CONTRACTOR 6462118, Инструкция по эксплуатации и техническому обслуживанию

Страница: 14 / 20

-13-
Fig. 17
Pencil Line
Male Joint - Laminate face down.
11. Firmly clamp the jig to the worktop ensuring it doesn’t move as you do so. Ensure the
clamps do not obstruct the router path.
12.
Cutting
- Follow steps 6 - 9 on page 6.
13.
Female Bolt Recesses (Fig. 18)
- Place the worktop with the laminate face down.
14. Fully insert three pins in holes marked
‘CB’ .
15. Clamp the jig to the worktop ensuring the three pins are firmly pushed up to the cut
out face and the worktop edge. Ensure clamps do not obstruct the router path.
16. Place the router into the front of one of the clamp bolt recesses, set the depth of
cut to 10mm max. Switch the router ON and machine the recess. When done,
switch the router OFF and wait for the cutter to stop spinning. Return the router to
the back again. Increase the depth of cut a further 10mm and machine the recess
again. When finished, switch the router OFF and wait for it to stop spinning.
17. Repeat step 16 for the other 2 recesses (other 3 recesses for 900mm worktops).
IMPORTANT
Recesses must be no deeper than 20mm maximum.
Fig. 18
Female bolt recesses - Laminate face down.
Cut Direction
Post Form Edge
Post Form Edge