Clarke CON2600, Инструкция по эксплуатации и техническому обслуживанию

Страница: 5 / 20

5
5. Start up speed. Always allow the angle grinder to run up to full operating speed
before applying it to the job.
6. Avoid operator fatigue. Stop the angle grinder at regular intervals for a short break to
rest hands and arms.
7. Applying the disc to the workpiece. Never bump the angle grinder disc on the
workpiece, or let the disc hit any other objects while grinding.
8. Dust masks. Always wear a dust mask when operating this angle grinder.
9. Do not abuse the mains lead. Never carry the tool by the mains lead or pull it to
disconnect it from the mains socket. Keep the mains lead away from heat, oil and
sharp edges.
10. Secure the work. Use clamps, or vices to hold the workpiece. Failure to secure the
workpiece could result in serious injury.
11. Maintain your tools. Keep all handles and grips dry and clean.
12. Remove adjusting keys and wrenches. Form the habit of checking to see that keys
and adjusting wrenches are removed from the tool before turning it on.
13. Avoid unintentional starting . Never carry a plugged in tool with a finger on the
switch. Ensure that the tool is switched off when plugging in to the mains supply.
14. Use outdoor extension leads. When the tool is used outdoors, only use extension
leads intended for outdoor use. Always make sure that the extension lead is
correctly rated.
15. Check damaged parts. A guard or other parts that is damaged should be properly
repaired or replaced, by an authorised service centre, unless otherwise indicated in
this user guide. Have defective switches replaced by an authorised service facility.
16. Accessories. Only use the recommended accessories. Ensure that the wheels and
discs are fitted in accordance with the manufacturer’s instructions.
17. Only use discs that comply with EN12413 or EN13236. Make sure that the disc used is
suitable for the no load speed of the angle grinder. See Specifications on page 16.
Check that the speed marked on the wheel dimensions are compatible with the
grinder. Check that discs are specifically for hand held angle grinder use.
18. Sparks and particles. Ensure that sparks and particles resulting from use do not
create a hazard, Use screens where appropriate.
19. Personal protective equipment. Always use protective safety glasses and hearing
protectors. Use other protective equipment such as gloves, apron and helmet
where necessary. If working at floor level, always wear knee pads.
20. Switching off. The disc will continue to rotate for a few seconds after the angle
grinder is switched off. Always wait until the disc has completely stopped before
putting the angle grinder down.
21. Use the disc guard. Do not use the angle grinder without the disc guard. Make sure
that the guard is securely fitted before operating the angle grinder.
22. Holding the angle grinder. Always hold the angle grinder with both hands. Ensure
that the workpiece is kept at waist height where possible. Never use the angle
grinder between the legs whilst sitting on the floor.
23. Feed direction. For cutting, always feed the disc into the work so that an upcutting
action is achieved.
24. Spindle lock. Do not operate the spindle lock while the spindle is still spinning.