Clarke CDP10B, Инструкция по эксплуатации и техническому обслуживанию

Страница: 8 / 28

8
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
UNPACKING
The drill press is delivered with the components shown on page 7.
Check the parts against the list. Should there be any deficiencies or damage,
you should contact your CLARKE dealer immediately where the product was
originally purchased. Do not discard the packaging until the machine is
assembled. The packaging consists of cardboard and appropriately marked
materials which can be sent to a re-cycling facility.
To protect the machine parts from moisture, a protective coating of light
machine oil will have been applied to the outside surfaces. Remove any
excess with a paper towel.
Take care when lifting the head assembly, considering its weight.
Before use, the machine must be mounted, and securely bolted, to a strong,
heavy workbench, of sufficient height that you will be standing upright when
working.
Ensure the work place is adequately lit, and that you will not be working in your
own shadow.
ASSEMBLY
COLUMN TO BASE
1. Bolt the column assembly to the base with the four bolts provided.
NOTE: Ideally, the base with column attached, should be firmly bolted to
the workbench, prior to the assembly of other components.
TABLE TO COLUMN
1. From the loose parts, locate the
worm and install it in the gear
housing of the table support,
liberally greased and pushed fully
home.
2. Push the crank on to the worm
spigot, protruding from the gear
housing, as far as it will go and
tighten the crank’s grub screw on
to the flat of the spigot using a hex
key.