18
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
For maximum performance, it is essential that the machine is properly
maintained. Always inspect it before use. Any damage should be repaired,
and faults rectified. Always remove the plug from the power supply before
carrying out any adjustment, servicing or maintenance.
Please refer to the trouble shooting chart on page 19. If you are unable to
rectify any faults, please contact your local dealer or Clarke International for
assistance.
MONTHLY (IF IN CONSTANT USE)
1. Check tightness of mounting bolts and head and column securing set
screws.
2. Check the drive belt for wear, and replace if frayed or damaged.
3. Blow out with compressed air, or vacuum clean out, any dust that may
have accumulated in the motor fan vents.
4. Apply a thin coat of wax paste or light oil to the table and column, for
lubrication, and to help prevent corrosion.
If the mains lead is damaged in any way, it should be replaced immediately.
LUBRICATION
All bearings are packed with grease
at the factory and require no further
lubrication.
Occasionally, lubricate the quill shaft
assembly with light oil if required.
AFTER USE
Remove all swarf from the machine
and thoroughly clean all surfaces.
Components should be kept dry, with
machined surfaces lightly oiled.
Always remove drill bits and store in a safe place.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste.
Any tools, accessories and packaging should be sorted, taken to a
recycling centre and disposed of in a manner which is compatible
with the environment.
Содержание CDP10B
Страница 1: ...OPERATION MAINTENANCE INSTRUCTIONS GC0514 DRILL PRESS MODEL NO CDP10B PART NO 6550020 ...
Страница 28: ......
