Clarke CDP10B, Инструкция по эксплуатации и техническому обслуживанию

Страница: 12 / 28

12
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
SETTINGS AND ADJUSTMENTS
TABLE
The table may be raised, lowered or
swivelled about the column, by
slackening off the table support
locking handle, adjusting the table
position accordingly and re-
tightening the handle.
It may also be tilted by loosening the
screw which secures the table to its
mount beneath the table, tilting the
table to the required position and
re-tightening the bolt shown in Fig 11.
A bevel scale is provided on the
table mounting, (measured in
degrees), to assist in setting the
required angle. However, for greater
accuracy the use of a protractor is
recommended.
For all normal operations, the table
should be set to 0°. This should be
checked with a set-square.
To check to ensure the drill is entirely
perpendicular to the table, install a large drill bit in the chuck, place a square
on the table, and bring it up to the drill. Adjust the table tilt if necessary, so that
the table is perfectly square.