Clarke CDP10B, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 28

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
3. Locate the three feed handles,
and screw them firmly into the
hub of the feed shaft as shown in
Fig.5.
CHUCK GUARD ASSEMBLY
NOTE: This task should be carried
out before the chuck is
installed.
1. Assemble the transparent guard
to the guard support using the
small bolt/nut and the two small
screws provided. (A small x-head
screwdriver will be required.)
2. Slide the Chuck Guard over the
Quill Shaft and nip up the pinch
bolt, temporarily, with the pinch
bolt facing the front (see fig 6).
Ensure the Quill Shaft/Spindle is at
the top of its travel.
INSTALLING THE CHUCK
1. Open the jaws of the chuck to
their maximum, using the chuck
key supplied. E
nsure the tapered
hole in the chuck is clean and
connect the arbor to the chuck
using the grub-screw and tighten
securely
.
2. Slacken the chuck guard pinch
bolt and turn the chuck guard so
the pinch bolt is towards the
rear
and tighten the pinch bolt.
3. Ensuring the arbor is clean and burr free. Seat the arbor into the quill shaft
till it bears against the drive spindle and tap the chuck firmly with a rubber
mallet until the tapered end of the arbor engages with the spindle.
CAUTION: IF A RUBBER MALLET IS NOT AVAILABLE, PROTECT THE CHUCK
WITH A BLOCK OF SCRAP TIMBER BEFORE STRIKING WITH A HAMMER.
ALWAYS ENSURE THE CHUCK JAWS ARE FULLY CLOSED BEFORE STRIKING
THE CHUCK