8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
NOTE:
Ensure the compressor is turned off.
1. Remove the travel plug from the air inlet at the bottom of the tool.
2. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done
regardless of whether or not a lubricated air supply is to be used.
3. Connect a suitable hose to the
tool as shown.
• Use the adapter supplied if
required.
4. Connect the other end of the hose
to the compressor.
You can fit a whip hose with a quick fit
coupling if required (available from
your Clarke dealer.)
FITTING THE BACKING PAD
1. Turn spindle lock until the knurled
portion contacts the flat surface
on the Spindle.
2. Thread the backing pad into the
spindle, by grasping the balancer,
with one hand and the pad with
the other. Do not over tighten.
3. Now turn the spindle lock so that
the knurled portion is away from
the flat on the spindle, and the
spindle turns freely.
4. DO NOT operate tool with spindle in locked mode as performance would
be severely affected, and a hazardous situation may result.
FITTING THE SANDING SHEET
1. Peel off the back of the self adhesive sanding sheet and stick it to the
backing pad.
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF
COMPRESSORS AND COMPRESSED AIR SUPPLY.
Содержание CAT121
Страница 1: ...OPERATION MAINTENANCE INSTRUCTIONS LS0211 DUAL ACTION SANDER MODEL NO CAT121 PART NO 3110877...
Страница 16: ......
