Clarke CAT121, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 16

11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
DAILY
• Drain water from air tank, air line and compressor.
• Pour a few drops of CLARKE Air Line Oil, into the air inlet. This should
be carried out regardless of whether or not an inline mini oiler is used.
If an inline mini oiler is not used, this procedure should be repeated
after every two to three hours of use.
NOTE: **Clarke Air Line Oil (part no. 3050825) is available from your
CLARKE dealer.
WEEKLY
• Remove the grub screw from the oil port on the side of the impact
wrench and insert a few drops of oil.
CLEANING
• Keep the body of the tool clean and free from debris, grit or gum
deposits in the tool which may reduce efficiency.
SERVICE AND REPAIR
All servicing and repair must be carried out by qualified service technicians.
NOTE: Please note that factors other than the tool may effect its
operation and efficiency such as reduced compressor output,
excessive drain on the airline, moisture or restrictions in the line, or
the use of connectors of improper size or poor condition which will
reduce air supply.
WARNING: MAKE SURE THAT THE TOOL IS DISCONNECTED FROM THE AIR
SUPPLY BEFORE STARTING ANY CLEANING, OR MAINTENANCE
PROCEDURES.