4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CONNECTING THE PUMP TO THE CONTROLLER
WATER CONNECTION
The controller should be connected to a good quality water pump and a
check valve should be fitted upstream of the pump. Confirm that the pump is
operating before installing the controller.
The controller can be installed anywhere between the pump and the first tap.
No taps should be fitted between the pump and the controller.
Use a flexible hose to connect the controller to the delivery pipe and tap.
The controller can be connected directly adjacent to the pump and between
the pump and the first outlet tap.
The controller must be installed in an upright position as shown by the direction
arrows on the label.
The vertical distance between the highest taps and the controller outlet being
no more than shown in the table below.
ELECTRICAL CONNECTIONS
The EPC1200 controller is fitted with two cables.
1. One is fitted with a standard 13 amp plug.
• When connected to the mains supply, this cable carries the supply
to both the controller and the pump.
2. The other cable should be fitted to a connecting socket for the pump.
3. If the controller is to be connected to an outdoor electrical supply, make
sure that both the plug and the socket are of a BS approved waterproof
design and are protected from the elements.
Starting
Pressure (bar)
Distance of controller
and highest tap max
distance (m)
Theoretical value
of the pump min
head (m)
Suggested value
of the pump min
head (m)
1.2
12
13
17
1.5
15
16
20
2.2
22
23
27
Содержание 7230699
Страница 16: ......