12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
For maximum performance, it is essential that the machine is properly
maintained. Always inspect before use. Any damage should be repaired and
faults rectified. The machine requires very little maintenance other than the
following guidelines.
IMPORTANT: Disconnect from mains power before cleaning.
1. Vacuum clean any dust or shavings that accumulate in or on the motor.
2. Check all cables periodically and ensure that they are in good condition
and not cracked.
3. Check the tightness of the mounting bolts.
4. Check the drive belt for wear and replace if it is frayed or otherwise
damaged.
5. Periodically lubricate the tail-stock, screw threads with engine oil such as
SAE20 or SAE30 grade if they become stiff to use.
6. Lightly lubricate the tail-stock and tool-post locking handles with oil if they
become difficult to use.
•
The ball bearings in the headstock and tail-stock spindles are greased and
permanently sealed at the factory and require no further lubrication.
REPLACING THE BELT, SPINDLE OR BEARINGS
NOTE: Numbers in brackets refer to the Parts Diagram on pages 14-16
.
To change the Drive Belt (53), Headstock Spindle (14) or Bearings (4) undertake
the following steps.
1. Remove the rear belt door (7) and knob (8).
2. Loosen the two 3mm hex screws
(2) and unscrew the hand wheel
(1) to remove.
Содержание 6501661
Страница 20: ......