25
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CHANGING THE CARBON BRUSHES
After extensive use, the carbon brushes will become worn and should be
checked if the motor seems to be lacking power. Replacements are available
from your dealer.
1. Unscrew the carbon brush cover
using a screwdriver.
2. The carbon brush should spring
out.
• If the carbon is worn to a length
of 6mm or less, or if the spring or
contact wire is burned or
damaged, replace both
brushes.
3. Replace each carbon brush
cover, taking care not to cross thread it.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted and taken to
a recycling centre for disposed in a manner compatible with the
environment.
By purchasing this product, the customer is taking on the obligation to deal
with its safe disposal in accordance with the Waste Electrical and Electronic
Equipment (WEEE).
In effect, this means that this product must not be disposed of with general
household waste. It must be disposed of according to the laws governing
Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal
facility. If disposing of this product or any damaged components, do not
dispose of with general waste. This product contains valuable raw materials.
Metal products should be taken to your local civic amenity site for recycling of
metal products.
WARNING: MAKE SURE THAT THE SAW IS SWITCHED OFF AND UNPLUGGED
FROM THE MAINS SUPPLY BEFORE INSPECTING OR CHANGING THE
CARBON BRUSHES.
