15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BASIC SAW CUTS
VERTICAL STRAIGHT CROSS CUT
1. Check and adjust the mitre table angles are correct as shown on page 21/
22.
2. Release the slide rail lock, and
push the saw head back to the
rear position.
3. Retighten the slide rail lock.
4. Place the wood to be cut against
the fence and secure with the
clamp.
5. Press the trigger release (1) with
your thumb and squeeze the
trigger (2).
• Let the motor reach full speed
before cutting.
6. Lower the head slowly, allowing
the blade to cut through the
timber and enter the kerf plate.
•
DO NOT
force the saw.
7. After the cut is complete, release
the trigger and allow the head to
return the head to its upper rest
position.
WARNING: THE BLADE WILL CONTINUE TO TURN FOR A SHORT WHILE
AFTER YOU RELEASE THE TRIGGER.
