13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Use an out-down-back motion.
• Pull the saw out, toward you
• Lower the saw head down
toward the workpiece,
• Slowly push the saw back to
complete the cut.
NOTE:
Do not allow the saw to
contact the top of the
workpiece while pulling out.
The saw may run toward you, possibly causing personal injury or
damage to the workpiece.
5. After completing the cut, release the trigger and wait for the saw blade to
come to a complete standstill before returning the head to its upper resting
position.
MITRE CROSS-CUT
1. Release the table locking handle
and move the arm left or right to
the required angle.
2. Lock in position by tightening the
table locking handle.
• Always make sure that the
table locking handle is securely
tightened before cutting.
NOTE:
When you mitre the end of a piece of wood with a small off-cut, place
the wood so that the off-cut is to the side of the blade with the greater
angle to the fence.
BEVEL CUTS
Bevel angles can be set from 45° left to vertical and can be cut with the mitre
arm set between zero and a maximum of 45° right or left.
1. Loosen the bevel lock and set the
bevel at the desired angle.
2. Tighten the bevel lock firmly.
3. Proceed as for a vertical straight
cross-cut.
• Let the blade cut freely. Do not
force the tool.
Содержание 6461518
Страница 28: ......
