10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
PREPARATION
For maximum stability the bandsaw should be bolted firmly to either a
workbench, a suitable stand, or a piece of plywood, 5/8”(15.9mm) thick, and
the plywood should be clamped firmly to a workbench whenever the
bandsaw is being used.
The saw must be located in an area large enough to allow you to work freely,
taking into account the likely size of your workpiece, ensuring adequate
lighting.
Make sure also that an adequate electrical supply is close by. Take extra care
if extension leads are used. Make sure that there is no possibility of tripping
over the lead when moving around the work area.
FITTING THE TABLE
1. Place the bandsaw on a flat level
surface
2. Remove the U Shaped Blocker
from the table (if fitted).
3. Fit the table to the bandsaw using
3mm allen key x 3 nuts and bolts
and 18mm flat washers (A,B & C).
Ensure the saw blade is central in
the table slot.
4. Screw the table stop bolt into the
underneath of the table (See page 11).
5. Re-fit the U Shaped Blocker to the table.
6. Hang the push stick and spanner on the hook/nut on the side of the
machine for safe keeping.
7. Fit the rip fence to the table if
required.
Содержание 6460072
Страница 24: ......
