Clarke 3402072, Инструкция по эксплуатации и техническому обслуживанию

Страница: 21 / 28

21
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
BAR MAINTENANCE
The following maintenance procedures must be performed to keep the chain
bar in good working order.
1. After approximatley 5 hours use, the bar should be turned, to ensure even
wear on the top and bottom of the bar. See page 22.
2. The bar rails should be cleaned every time the bar is turned, or the chain is
removed. Using a suitable implement, clear any debris from the bar rails.
This will keep the oil passages open and provide correct lubrication to the
bar and chain.
OTHER MAINTENANCE PROCEDURES
1. After use, clean all excess sawdust, chippings and debris from the
chainsaw, chain and chain bar using a soft brush.
2. Keep the air vents (end of motor housing) clean to prevent the motor
overheating.
3. Keep the main body of the chainsaw clean using a soft cloth.
4. Check the chain tension regularly and adjust as often as necessary to keep
the chain snug on the bar. A new chain will require more frequent
adjustment.
5. Check the mains cable before each use. Do not use the chainsaw if the
cable is damaged in any way.
6. Always check the chain brake before each use, following the procedures
on page 13 of this user guide.
7. Make sure that the automatic oiler system is working properly. Keep the oil
tank filled with chain oil during use.
STORAGE
• Always store the chainsaw with the guard in place.
• Make sure that the chainsaw is stored out of the reach of children.
• Never hang the chainsaw by the handle, always store the chainsaw on
a flat stable surface.
WARNING: MAKE SURE THAT THE CHAINSAW IS DISCONNECTED FROM
THE MAINS SUPPLY BEFORE CONTINUING.