8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
CONNECTING THE AIRLINE
NOTE:
Ensure the air supply is turned off.
1. Remove the travel plug.
2. If required, connect an in-line mini
oiler to the tool. Refer to the
instructions supplied with the mini-
oiler before use.
• A mini oiler helps to prolong the
life of any air tool.
3. Connect a suitable hose. This can
be done using either the male
adaptor supplied or using a mini
oiler from your CLARKE dealer.
4. If a mini-oiler is not being used, run a few drops of oil through the tool
before use. It can be entered through the airline connector or via the hose
at the nearest connection to the air supply.
5. Connect the other end of the hose to the compressor.
6. Turn on the air supply and check for air leaks. Rectify any found before
proceeding. Set the working pressure to 90psi/6.2 bar for best
performance.
• PTFE tape may be useful for sealing threaded connections.
7. Place a sheet of paper next the exhaust port and hold the throttle open for
approximately 30 seconds. The oil volume is correctly set when a light stain
of oil can be seen on the paper. Excessive oil should be avoided.
Your air tool is now ready for use.
You can fit a whip hose with a quick fit coupling if required (available from
your CLARKE dealer).
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND A COMPRESSED AIR SUPPLY.
Содержание 3110470
Страница 16: ......
