Clark S20 D, Руководство оператора

Страница: 153 / 170

How to Perform Planned Maintenance 7-27
Section 7. Planned Maintenance and Lubrication
Park the forklift truck on level ground,
incline the mast forward to the
largest extent, and check oil level of
the drive axle.
When the oil temperature is same as
the ambient temperature, makeup
the oil up to "LOW" mark on the oil
level gauge. When filling oil up to
"FULL" mark at temperature beyond
engine running temperature, oil may
overflow.
Lubrication
Truck Chassis Inspection and Lubrication
Lubrication and inspection of truck chassis components, including
steer wheels, steer axle linkage, steering cylinder, and wheel
bearings are easier if the truck is raised and blocked up under the
frame. Refer to your Service Manual for additional information on
machine blocking and jacking. Also refer to Service Manual for the
location of grease fittings.
WARNING
!
Do not raise the truck by lifting under the counterweight.
Inspect the steering cylinder piston rods, seals, and fasteners for
damage, leaks, and looseness. Lubricate the steer axle linkage rod
ends and linkage pivot points. Be sure to clean the grease fittings
before lubricating, and remove the excess grease from all points
after lubricating. Lubricate miscellaneous linkage as needed.
Upright and Tilt Cylinder Lubrication
Clean the fittings and lubricate the tilt cylinder rod end bushings
(forward end) and both the base rod-end bushings (rear end). Clean
and lubricate the upright trunnion bushings
U
LOW
FULL