Clark CGC40 L, Руководство оператора

Страница: 101 / 128

How to Perform Planned Maintenance 7-15
Section 7. Planned Maintenance and Lubrication
wear, rust, corrosion, cracked or broken links, stretching, etc. Check
that the lift and carriage chains are correctly adjusted to have equal
tension. Check that the lift chain anchor fasteners and locking means
are in place and tight. Inspect all lift line hydraulic connections for
leaks.
IMPORTANT
Uprights and lift chains require special attention and
maintenance to remain in safe operating condition. Refer
to “Lift Chain Maintenance” in this Section for additional
information.
Forks
Inspect the load forks for cracks,
breaks, bending, and wear.
The fork top surfaces should be
level and even with each other.
The height difference between both
fork tips should be no more than
1.5% of the blade length.
WARNING
!
If the fork blade at the heel is worn down by more than 10
%, the load capacity is reduced and the fork must be
replaced.
Inspect the forks for twists and
bends. Put a 2"-thick metal block,
at least 4" wide by 24" long with
parellel sides, on the blade of the
fork with the 4" surface against
the blade. Put a 24" carpenter's
square on the top of the block and
against the shank. Check the fork
20" above the blade to make sure
it is not bent more than 1"
maximum.
A
10% of "A" is max.
wear allowed
1.5% is max.
height difference
20"
1
"
max