Clarion/Hyperlink Bridge Kit Installation Manual
Rev. A Page
21
Hyperlink Technologies, Inc.
Power-up
Please follow the the steps below to power up the
equipment.
1. Power on the Clarion radio first. The power button on the front of
the radio is not operational. When the power cord is inserted into
the radio it will power up. The following is the LED sequence that
should appear after you power up the radio (self-test). On power
up the RX light will blink once and about two seconds later the TX
light will blink 5 times, the power light will stay on. If the radio
does this then it has passed the self-test.
2. Now power-up the transceiver –You should have the power led
and the link light on. The cat 5 cable has to be in the transceiver
to get the link light.
3. If you are using an non-amplified system you should be able to
connect to the other computer. For amplified go to step 4.
4. Power-up the DC Power Injector. A green light will come on
verifying that there is power to the PI. Now look at the AMP–it
should have a green LED lit up.
5. Install the antennas and you should be able to connect to the
other computer and transfer files.
Now just follow the same steps to do a long-range link and it should
go trouble free.