Clarion/Hyperlink Bridge Kit Installation Manual
Rev. A Page
12
Hyperlink Technologies, Inc.
ANTENNA SYSTEM CONNECTION
Warning
The M10II may only be operated using one of the approved
antenna kits described herein. All antenna system
components are equipped with unique connectors.
Although these connectors may look similar to standard
types they are not compatible with them. Attempting to
attach standard connectors to system components can
cause damage to the connectors and attached equipment.
In addition, the M10II
External antenna port
is equipped
with a special
Antenna recognition
function which disables
the transmit function in the event a non-approved antenna
system is connected to the radio.
Surveying the Antenna Site
Before beginning system installation, emphasis should be placed on system
planning. It is important that no large obstructions exist near the antenna, such
as retaining walls, chimneys, air-conditioning units or other antenna masts.
These types of objects can have an impact on the antenna system performance.
Plan to mount the antenna as high as possible. You will need enough mast to
elevate the antenna approximately 15 feet above the roof or above any
obstruction that might be in the antenna's signal path.
You will need to identify the location where the antenna cable will be routed. If
you run the antenna cable through the roof, a water-proof fitting will be required.
Consult a building contractor or licensed electrician to help you with the routing if
necessary. Take note of the length of the mast you will need and the type of
mounting hardware required. The amplified antenna kit is shipped with U-Bolt
mounting hardware which should be ideal for mounting the antenna and amplifier
to most types of mast. Also, make plans on how you are going to talk to the
person at the remote antenna while you are going through the antenna alignment
procedure. For example, cellular phones or walkie talkies can be used.
