Clarion/Hyperlink Bridge Kit Installation Manual
Rev. A Page
16
Hyperlink Technologies, Inc.
M10II LED Diagnostic Display
During power-up, the front panel LEDs on the M10II provide some diagnostic
information. Refer to the table below for LED diagnostic information.
Label
Color
Description
MAU
Green
Indicates MAU signal (upload or download) is active.
TX
Red
1.
During the power-up cycle, it blinks on and off slowly
five times in approximately one second to indicate that
the firmware has passed its integrity; or, it flashes on and
off very rapidly for four or five seconds to indicate that
the firmware has been damaged. No indication described
above is available in some case of hardware failure.
2.
After normal power-up cycle, it Indicates radio
transmission.
3.
During the firmware-uploaded cycle ; refer description
attached on the new firmware.
RX
Green
1.
Indicates radio signal detection.
2.
Sometimes flashes even if no true signal receives
because of optimized false alarm rate.
Power
Red
1.
It turns on at approximately 1/4 second after applying
the power to indicate activation of the unit.
2.
If the hardware check sequence fails, it turns off
automatically at approximately 5 seconds after power on.
