Clarion/Hyperlink Bridge Kit Installation Manual
Rev. A Page
20
Hyperlink Technologies, Inc.
Installation
Hyperlink recommends that you use two computers directly off a
working Network segment to test the operation before the
installation of a long-range link.
The following steps are for two computers that are off of a working
network. Do not power up any equipment until all equipment is
connected.
1. Connect the transceiver to the Clarion radio.
2. Connect the CAT 5 Patch cable from the transceiver to the
computer network card.
3. Connect the Clarion antenna adapter cable to the EXT ANT on the
back of the Clarion radio.
4. Connect the Clarion adapter cable to the lightning protector for
non-amplified and into the DC Power Injector for amplified
systems.
5. Connect the 50 feet of low-loss cable to the DC Power Injector or
lightning protector.
6. Amplified systems only:
connect the amp to the end of cable.
7. Connect the Antenna to the end of the cable or for amplified
systems connect to the amp.
8. Now that everything is connected go back and check that all
connectors are tight .