3
Installation instructions & user manual
9120-34373 v4.00 Nov 2018 - ZIP DBX DEX
Technical support
Tel: 0345 6 005 005 email: [email protected] www.zipwater.co.uk
SAFETY INSTRUCTIONS
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE
TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. RETAIN THESE
INSTRUCTIONS FOR FUTURE USE.
WARNINGS
• Installation, commissioning and maintenance of this appliance must only be carried out by
a competent installer who will then be responsible for adhering to all relevant standards
and regulations.
• If inlet temperature is up to 70 °C (eg. fed from a solar supply) mixing with cold water will
be required to ensure a safe temperature at the outlet.
• Do not remove the front cover under any circumstances before switching off the mains
electrical supply to the unit.
• Never make technical modifications, either to the appliance itself or the electrical leads and
water pipes.
• The appliance must be earthed at all times.
• Pay attention to the fact that water temperatures in excess of approx. 43 °C are perceived
as hot, especially by children, and may cause a feeling of burning. Please note that the
fittings and taps may be very hot when the appliance has been in use for some time.
• The values stated on the rating plate must be observed.
• In case of malfunction, disconnect the mains power supply immediately. In case of leaks,
cut off the mains water supply instantly. Repairs must only be carried out by the customer
service department or an authorised professional.
• This appliance can be used by children aged 3 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have
been given supervision or ins truction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be performed by children without supervision.
• If the appliance is factory equipped with a power supply cable, it must be replaced with an
original spare cable from the manufacturer in case of damage by an authorised technician
in order to avoid any hazards.
• In accordance with EN 60335, the appliance must be permanently connected to the supply
through an isolating switch with a contact separation of at least 3 mm in all poles and be
protected by a suitably rated RCD.
• The wall bracket must be secured with the supplied screws and dowels. The appliance
must be secured to the wall bracket. The appliance may only be operated if it has been
properly mounted on the wall bracket.
• The required water resistance may not fall below the value stated on the rating plate at
any time.
