clage FX Next, Инструкции по эксплуатации и монтажу

Страница: 30 / 208

20
EN
1 . Make sure that the power supply to the instantaneous water heater is
switched on (fuse) and that the display (if available) of the instantane-
ous water heater shows the latest set value .
2 . After inserting the batteries into the radio remote control (fig . A2), the
language selection appears . Select your preferred operating language
and confirm with “ OK ” .
3 . A maximum of ten Bluetooth devices found are then scanned and
listed (fig . A7) . The device name is composed of the model abbrevia-
tion and the last 4 digits of the serial number (for CEX/XFX model
abbreviation only) . The scan can be repeated by selecting
.
4 . Select your instantaneous water heater and confirm with “ OK ” . The
PIN entry appears (fig . A8) .
5 .
DEX/DFX/DSX:
Enter the first four digits of the Bluetooth PIN and
confirm with “ OK ” . The PIN can be found on or at the type plate of
your instantaneous water heater .
CEX/CFX:
Enter the last 4 digits of the serial number . The serial num-
ber can be found on the type plate of the instantaneous water heater
and in the warranty booklet .
6 . The remote control is now connected to the instantaneous water
heater and starts data synchronisation (fig . A9) . This may take a few
seconds . The remote control then switches to the Main control .
6. Initial operation
7 . Test the function by changing the setpoint via the remote control and
checking the water temperature .
If the registration was not successful, the message “Connection failed”
appears briefly . The view then changes back to the list with the Bluetooth
devices found .
If your device is not found even after several attempts, check the plug-in
position of the radio adapter .
Notes:
• With no remote control registered or without working radio connec-
tion, the instantaneous water heater heats to the prior selected set
temperature .
• After replacing the batteries, a new registration is not required .
• Only register again after performed factory reset or when the remote
control display continually indicates “No device connected” .