clage 3200-36450, Инструкции по эксплуатации и монтажу

Страница: 36 / 314

36
EN
DEX Next S
3. Remote control
Mounting the wall bracket
• Before attaching the wall bracket to the wall, ensure that the remote control has
radio contact to the instantaneous water heater from its designated position and is
protected against splashing water.
• The wall bracket of the remote control can either be attached securely with the
included adhesive tape, after stripping off the protection film (as shown in the fig-
ure A), on a rigid board (e.g. tile) or with suitable dowels (Ø 4 mm) and screws (as
shown in the figure B).
• When mounting with adhesive tape, ensure that the mounting surface is dry and
free of grease and soap.
• When using the adhesive tape it is not possible to further adjust the position
because of the strong adherence of the glue. Therefore, pay attention to a horizon-
tal alignment when attaching it.
• The remote control is magnetically retained at the wall bracket.
• Keep the remote control and wall bracket away from credit cards or other cards
with magnetic strips. The built in magnets can damage the card’s magnetic strip.
Initial operation
By the time the power settings have been carried out and the power supply to the
instantaneous water heater is enabled, insert the batteries into the remote control.
Registration of remote control at the instant water heater
1. Make sure that the power supply to the instantaneous water heater is switched on
(fuse).
2. After inserting the batteries, the remote control briefly displays all symbols. Then
“
8A
” and the percentage of battery charge are displayed and the display changes to
the PIN entry “
P1
”.
3. Press and to change the current digit. Press to change to the next digit.
After entering “
P4
” and pressing , the PIN is applied.
4. Enter the first four digits of the Bluetooth PIN and confirm with . The PIN can be
found on or at the type plate of your instantaneous water heater.
5. After entering the pin, the remote control automatically connects to the instanta-
neous water heater, “
d1
” appears during the registration procedure. I
6. Once connected, the display of the remote control switches to the setpoint value
display.
In the case of an unsuccessful registration the display indicates “
E1
” and a flashing
radio signal after 45 seconds. The remote control quits the registration process and
switches to standby mode. By pressing a key the registration process will be repeated.
Technical data
Model
FX 3 Remote control
Operating voltage 3 V
Type of battery 2x AAA Alkaline 1)
Type of protection IP 20
Transmission range 10 metres incl. barrier
Transmission power < 8 mW
Transmission and receiv-
ing frequency range
2.4 – 2.4385 GHz
Radiation undirected
Approvals Europe EN 300 328 / CE
1) Do not use rechargeable batteries.
Figure B:
Optional installation with dowels and screws
Figure A:
Installation with adhesive tape