‑ ‑
7
) (included) until the filter returns
to its original white color, then rinse
thoroughly with cold water.
NOTe: Never use soap or detergents to
clean the UltraCarb Ceramic Filter. Be
sure to be very careful when handling
the filter as it will break or crack if
dropped.
5.
Set filter aside.
6.
each time the UltraCarb Ceramic Filter is
cleaned or replaced, it is recommended that
the Cleansource Drinking Water system is
cleaned and sanitized.
Fill the Filter Housing with warm soapy water
and scrub the inside surface with a soft brush or
sponge. To avoid scratches, do not use abrasive
pads or cleaners inside the filter housing. Rinse
thoroughly.
7.
Add 2 capfuls of unscented chlorine bleach to the
Filter Housing and fill 2/3 full with cold water.
Do not yet install the replacement
filter.
8.
Leaving the chlorine solution in the Filter Housing,
invert the Base Assembly and screw the base
into the Filter Housing. Make sure the O-ring is
Figure 9
