Claas K5D00100, Руководство по ремонту

Страница: 30 / 252

AXLES & STEERING 1.20
6. Position the brake pack on a suitable press, fit the
belleville washers (11) (the lower washer should
have the concave side facing down and the upper
washer should have the concave side facing up). Fit
the sleeve (12) (with the ring seat outermost).
7. Position the special tool Part No. CA715056, (10)
on assembly and press into brake pack until circlip
(13) can be fitted. Fit circlip and carefully release
press. Make sure belleville washers are located
centrally.
1. Brake pack
2. Bearing track
3. O-ring
4. O-ring
5. Thrust pin (Qty 3)
6. Negative acting brake piston
7. Circlip
NOTE: The following assembly procedure, for the
brake pack, must be carried out on both left and
right units.
1. Position flange of brake pack (1) on a flat surface
and fit the bearing track (2) to brake pack using
special tool Part No. CA715299, handle Part No.
CA119033 and a hammer.
2. Fit O-rings (3 & 4) to the three thrust pins (5).
3. Fit the thrust pins to the negative acting brake
piston (6) and secure with circlips (7).
4. Fit O-rings (8 & 9) to the inner and outer faces of
the negative acting brake piston.
NOTE: Use an eyebolt screwed into the brake pack,
and a lever to press the piston into the brake pack.
5. Apply a thin layer of grease to the piston contact
surfaces and O-rings. Position piston on brake pack
and using special tool Part No. CA715056, (10)
press piston into brake pack until it is just located,
then remove special tool.
Brake pack and differential housing
Take care when compressing the
belleville washers, use a press and
make sure all components are
square before applying pressure.
The upper belleville washer must be
fitted with the concave side facing
up.
8. O-ring
9. O-ring
10. Special tool, Part No. CA715056
11. Belleville washer (Qty 2)
12. Sleeve
13. Circlip