- 71 -
GS V m
…
(1)
GS V m n
…
(2)
[Function]
Cutting the paper
[Code]
(1)
<
1D
>
H
<
56
>
H
<
m
>
(2)
<
1D
>
H
<
56
>
H
<
m
><
n
>
[Range]
(1)0
≦
m
≦
1
、
48
≦
m
≦
49
(2)65
≦
m
≦
66
[Outline]
Performs the specified paper cutting.
m
Function
0,48 Full
cut
1,49 Full
cut
65
Paper feed by “cut po basic calculation pitch” and full cut
66
Paper feed by “cut po basic calculation pitch” and full cut
[Caution]
• In STANDARD MODE, this command only works when it is entered at the beginning of
a line.
• Control to make the length of cut paper less than 10 mm is not executed.
For (1):
• Executes cutting of paper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n
≠
0, the paper is fed
by “n×basic calculation pitch” inches past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
• The paper feed amount is calculated with the vertical basic calculation pitch (y). A
fraction resulting from the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.
