1. Measures Against Possible Problems
If the solar powered watch is insufficiently charged or its battery power is
considerably consumed, the watch functions are limited to a certain range and
the watch warns the user of its status by various means such as abnormal
indications.
To avoid such a power failure, always keep the battery sufficiently charged.
If the depth indication is less than 4 m (15 ft), press button
(A)
for 2 seconds
or more to switch to the Time mode. If the depth indication is more than 4 m (15
ft), adjust the watch according to section "K. All Reset/Adjusting Hand
Position".
* The modes cannot be switched.
If the battery power drops, the modes cannot be switched under the following
conditions.
* When the function hand points to "NG", the watch cannot be switched over to
the Diving mode even if the water sensor gets wet.
* When the watch is in the insufficient charge warning status, the mode cannot
be switched over to the Chronograph mode.
In such a case, sufficiently charge the battery.
* For details, refer to "B. Warning Functions of this Solar Powered Watch".
* The second hand moves irregularly every 2 seconds.
Note this as the time setting warning that warns of incorrect time indication
caused by a temporary stoppage of the watch. In such a case, sufficiently
charge the battery, and then set the watch for the correct time.
*
For details, refer to section "B. Warning Functions of this Solar Powered
Watch".
* For details, refer to section "B. Warning Functions of this Solar Powered
Watch".
When the user is at high altitudes or is on an airplane flight, the watch may
unexpectedly be shifted to the Diving mode because of a sharp change in the
atmospheric pressure (pressure change equivalent to the depth of 1 m/5 ft). If it
occurs, the watch may fail to switch from the Diving mode after the user goes
back to the ground level, because the depth meter function didn't reset the depth
indication to "O m (O ft)". In addition to the aforementioned case, the watch may
enter the Diving mode because perspiration or other moisture activates the water
sensor.
* The watch does not switch to the Time mode from the Diving mode (depth
indication mode).
* One of the hands is out of the correct position.
If a strong shock or static electricity is given to the watch by careless
handling, the hands may show an incorrect indication.
• Adjust the function hand (chronograph second indicator) when it is out of
the "O" position (the mode hand functions normally) in the following
conditions referring to section "J. Setting Function Hand at "O" Position".
1) When the watch is in the reset status of the Chronograph mode
2) When the watch is set to the time adjustment mode (the crown is pulled to
the second click stop position)
3) When the watch is in the diving mode (standby status).
• In the case the function hand and/or the mode hand are out of their
respective "O" position in other modes, adjust the hand(s) referring to
section "K. All Reset/Adjusting Hand Position".
Note this as the insufficient charge warning that warns the user of a decline
in battery power. If it occurs, immediately recharge the battery sufficiently.
* The second hand jumps 2 seconds every 2 seconds.
Return to Table of Contents
Return to Table of Contents
