<How to recall the memorized maximum depth>
(1)
Press button
(B)
in the Time mode or Diving
mode (when depth indication is 0 m/Oft). The
function hand indicates the memorized maxi-
mum depth.
(2)
To cancel the maximum depth indication,
press
button
(B)
again.
*
Indication of the memorized maximum depth
continues for 30 seconds and is automatically
canceled after that.
x
The memory of the maximum depth of the last dive is held until the watch is
used in the next dive.
x
If the maximum depth in diving is less than 1 m (5 ft), it is not memorized.
On the other hand, if the maximum depth exceeds 50 m (125 ft) it is memorized
as an over-zone depth.
x
When the watch is used in diving for the first time, it occasionally shows
data stored during inspection prior to shipment.
H. Chronograph Made
The chronograph function enables this watch to measure time in units of 1 second
for a maximum of 49 minutes 59 seconds. When it has reached 50 minutes, since a
time measurement was started, the chronograph stops measuring time and the hands
move to the reset position.
<Chronograph indication - Reset position -> *
If the watch is left in reset
status in the chronograph mode for 3
minutes, it automatically switches to the
Time mode.
~
* The mode cannot be changed while the time is being measured in the Chronograph
mode. If the mode is changed while in the stop-state of the Chronograph mode, then
indication is cleared.
* If the function hand or/and mode hand do not reset to their respective "O"
positions when the watch enters the Chronograph mode or the chronograph is reset,
adjust the hand(s) to the "O" position referring to section "1. Measures Against
Possible Problems".
* The watch cannot be switched to the Chronograph mode from the Diving mode.
<How to measure time>
(1)
In the Time mode, press and hold button
(A)
for 2 seconds or more to switch
the watch to the Chronograph mode. As a result, both the function hand and mode
hand quickly go to their respective "O" positions and then stop.
(2)
Each time button
(B)
is pressed, both the hands start and stop alternately.
(3) If button
(A)
is pressed while both the hands are stopped, the chronograph
switches to the reset status.
Return to Table of Contents
Return to Table of Contents
