Citizen CBM-272, Руководство пользователя

Страница: 44 / 157

— 25 —
1
2
3
4
5
4.12 Paper Near End Function
If the paper is running out, the PNE sensor informs the host computer that the
paper is running out, by means of a signal output or the PAPER lamp on the panel.
The PAPER lamp is illuminated unconditionally.
If the PNE sensor detects that the paper is running out, the PAPER lamp will be
illuminated.
If PNE is enabled, the parallel interface will output PE. (At initial setting)
Printing is allowed up to about 1.5 m. (Initial value) After printing or feeding the
paper by a specified amount, the parallel interface will output BUSY and FAULT,
and serial interface will output DTR to stop printing, respectively.
Replace the paper according to the procedure in “4.7 Inserting the Paper.”
After replacing the paper, cancel the BUSY (DTR), FAULT, and PE outputs.
DS1-1
State
OFF
ON
PNE
Function
Disabled
Enabled
PE Signal Output Setting
by Command
When PE is selected*
When PNE is selected
When PE is selected
When PNE is selected*
PE Output
When PE is detected*
When PNE is detected
When PE is detected
When PNE is detected*
BUSY (DTR)/
FAULT Output
When PE is detected*
When PE is detected
When printing stops
due to PNE*
When printing stops
due to PNE
PAPER
Lamp
At PNE*
At PNE
At PNE
At PNE*
(1) The following lists the outputs made by the near paper end function and the
paper end function. The output state can be changed by the DIP switch or a
command.
*Mark : Default setting
PNE : Paper Near End
PE : Paper End