CBM-270 User’s Manual
CITIZEN
9
P
PP
PR
R
R
RE
E
E
EC
C
C
CA
A
A
AU
U
U
UT
TT
TIIIIO
O
O
ON
N
N
NS
S
S
S F
FF
FO
O
O
OR
R
R
R IIIIN
N
N
NSSSST
TT
TA
A
A
ALL
LL
LL
LLA
A
A
AT
TT
TIIIIO
O
O
ON
N
N
N
·
Do not use or store the equipment in a place exposed to fire, moisture, or direct sunshine,
or in a place near a heater or thermal device where the prescribed operating temperature
and humidity are not met, or in a place exposed to much oil, iron powder, or dust. The
equipment may become out of order, emit smoke, or catch fire.
·
Do not install or use the equipment in a place like a laboratory where chemical reactions
are expected, or in a place where salt or gases are contained in the air. There is a danger
of fire or electric shock.
·
Install the printer on a flat, stable desk or table that is free from vibration, in a well-
ventilated place.
·
Do not install the printer at a location where its operation could be hindered.
·
Do not place anything on the printer or leave small objects, like a clip or pin, around it. A
foreign object could cause trouble if it gets inside.
·
Do not use any sharp-pointed object, such as a pen, for example, to touch the operation
panel of the printer. It could cause trouble.
·
Do not use the equipment near a radio or TV receiver. Do not share the power from a plug
socket a radio or TV receiver is connected to. It may cause a reception problem.
·
Use the equipment only at the specified power supply, voltage and frequency. Otherwise,
it may emit smoke and catch fire or cause other problems.
·
Connect only the specified power source. Use of an unspecified power source could cause
trouble or smoke/fire.
·
Confirm that a plug socket used for connection has sufficient capacity.
·
Avoid connecting a power cable to a plug socket shared by other devices or extending the
wiring too far. It may result in the cable catching fire or a power outage. Also, do not
step on or apply an excessive force (Pull, load) to the cable, and do not use the printer with
such a force applied to it.
·
Never connect a grounding cable (Frame ground) to a gas pipe. There is a danger of
explosion. When connecting or disconnecting the grounding cable, be sure to disconnect
the power cable and the power plug from the plug socket.
·
When connecting/disconnecting the cables, be sure to turn off the power first, including the
connected side, and then connect/disconnect them, holding a plug and a connector.
Pulling the cable itself could cause it to snap or become damaged.
·
Connect a power cable or a connector cable securely. If a reverse-polarity connection is
made, internal elements may be broken or a mating device may be adversely affected.
·
Use a shielding wire or twisted pair wire for a signal line, in order to minimize noise effect.
Do not route the cable too long or connect it to a noisy device. Connection to a noisy device
could cause erroneous printing due to corrupt data, and so on.
·
Use the equipment in an environment where there is a plug socket near the main body and
you can easily disconnect the power plug from it, to shut off the power.
·
When the equipment will not be used for a long period of time, unplug it and remove the
paper roll from it.
·
When transporting the equipment, remove the paper roll from the paper holder.
Содержание CBM-270
Страница 50: ...CBM 270 User s Manual CITIZEN 50 ...
Страница 94: ...CBM 270 User s Manual CITIZEN 94 German ...