Cissell L36TD30ME, Техническое руководство

Страница: 21 / 53

Page 21
S6162-BS-MMC-010/12489
O P E R A T I N G I N S T R U C T I O N S
Step 1. After loading the dryer tumbler with the washed clothes load, proceed to
close the loading door.
Step 2. Timer Models - Turn drying timer knob to the desired drying time.
Step 3. Temperature Selector - Select temperature per type of load being dried in the
dryer.
High
Heat - mixed and heavy fabrics - 180° F exhaust temperature.
Low Heat - poly knit synthetic-blends-light weight fabrics - 160° F exhaust
temperature.
Step 4. Turn ON/OFF switch to “ON” position.
Step 5. Push the Push-to-Start button. The “Drying” light will be “On”.
Note: After the dryer has worked for your “set” amount of time, the machine
will
go into the automatic cool-down setting (the “Cool-Down” light will be
“On”). The machine will operate automatically until the exhaust
temperature reaches 135° F.
At this point the machine will stop and a “buzzer” will be turned “On”.
Step 6. Turn “ON/OFF” switch to “OFF”. At this point, the buzzer will stop.
G E N E R A L M A I N T E N A N C E
1. CLEAN LINT TRAP DAILY: Remove lint daily before starting operation.
A clean lint trap will increase the efficiency of the dryer, as the moisture
laden air will be exhausted to the atmosphere more quickly.
2. KEEP BASKET AND SWEEP SHEETS CLEAN: Check periodically and
clean as often as required. The basket and sweep sheets within the dryer
are
easily accessible for cleaning by removing the front panel of the dryer.
Take screws out of front panel, then lift panel off.
3. PULLEYS (SHEAVE) AND BELT: Keep belts clean. Oil and dirt will
shorten the useful life of a belt. Never allow a belt to run against the belt
guard. Check belts periodically for alignment. Pulley shafts must be
parallel and the grooves must be in alignment. To align pulley, loosen set
screw and slide pulley in or out to align up with the other pulley. Tighten
set
screw securely.
4. ELECTRIC MOTORS: Keep motors clean and dry. Occasionally blow
dust out of winding. After 3 years normal or 1 year heavy duty service all
oil.
No reoiling normally required for light duty with total operating time
under 25,000 hours. Use electrical motor or S.A.E. 10 oil. DO NOT
OVER OIL.
5. GEAR REDUCER: Maintain oil level in gear reducer 1/2 depth of oil cup.
Transmission oil to meet military specification MIL-L-6086B.