Cissell HD75ST, Руководство пользователя

Страница: 34 / 55

Page 34
Basket Alignment—Double Motor Model
1. Loosen the 4 gear reducer mounting bolts (1, 2, 3 and 4) on rear of
dryer, and 2 adjusting bolts #5, on gear reducer housing.
(Figure 3)
2. Place one “A” and two “B” diameter pins inside the drying
compartment between the rim of the basket opening and the
rim of the door opening in the positions shown in Figure 1
and Figure 2. Check the two “B” pins for equal clearance.
3. With the pins in postions, tighten the two #5 bolts until flush
against back of dryer. Re-tighten gear reducer mounting bolts
in the numerical order incidated in Figure 3. Tighten lock nuts
#6 to secure bolts #5 in position. Then remove pins.
4. Check the space between basket and door opening at “A” pin
and “B” pin positions (Figure 2). If the gap is not
approximately the same on both sides, repeat steps 1, 2, and
3.
NOTE
Use short sections of round steel rod for pins or drill bits may
be used in place of round rod.
BASKET ALIGNMENT—
DOUBLE MOTOR MODEL