Page 6
DETAILS OF CONTROL BOARD AND OPTIONS
Switch set #1
Switch
O N
O F F
#8 F/C
Deg F
Deg C
#7 SFTY-EN
enabled
disabled
#6 6-ADD
+ 6 Min.
0
#5 REPEAT S/E
Start
End
#4 2 DEG
+ 2 Deg.
0
#3 5 DEG
+ 5 Deg.
0
#2 10 DEG
+ 10 Deg.
0
#1 20 DEG
+ 20 Deg.
0
#8
F/C. Selection of Deg F or Deg C for temperature display. Position the
switch for the desired unit.
#7
SFTY-EN. The switch enables the “safety tumble” feature. To disable,
position this switch in the OFF position.
#6
6-ADD. Used in conjunction with the HEAVY fabric selection. When
switched to the “+ 6” position, an additional 6 minutes of drying time will
be added to the cycle when HEAVY has been selected. This is to
compensate for “hard to dry” loads or mixed loads.
#5
REPEAT S/E. This switch works in conjunction with the REPEAT LAST
CYCLE button. The parameters (mode, time, temperature) of the cycle will
be stored either at the START or the END of the cycle based on this switch
setting. The parameters that are stored will be used by the control when
the REPEAT LAST CYCLE button is pressed prior to starting a drying
cycle.
#4
2 DEG. Adds 2 Degrees to the differential temperature.
#3
5 DEG. Adds 5 Degrees to the differential temperature.
#2
10 DEG. Adds 10 Degrees to the differential temperature.
#1
10 DEG. Adds 10 Degrees to the differential temperature.
N O T E :
The differential temperature is part of the heating logic. The heat turns off
when the temperature in the dryer reaches the temperature set for the
drying cycle. The temperature has to drop a set number of degrees below
the drying temperature before the heat will turn on. The difference
between the cycle temperature and the temperature to turn the heat on is
called the differential temperature. This control allows the differential to
be set between 5 and 25 degrees. The control “sums” the values set on the
switches but will not go lower than 5 nor greater than 25. If the sum is less
than 5 the control will default to 5. If the sum is greater than 25, the
control will default to 25.
Содержание ACDCMAN407
Страница 4: ...Page 4 CONTROL PANEL ILLUSTRATION...
Страница 7: ...Page 7 CONTROL BOARD AND OPTIONS ILLUSTRATION...
